You are currently viewing 5 Ways to Improve the Plastering

5 Ways to Improve the Plastering

Plastering a wall requires a strong skill set that enables one to minutely control the movement of the hands so that the final plastered wall has a shiny, high-quality polish. Though not many people take to plastering the walls by themselves, there are homeowners who do try it out. And if you are one of them, then the below tips should help you improve your plastering skills.

Right Plaster Mix

Before you start plastering the wall, you have to ensure that the application itself is mixed perfectly. If not, then the plastering you put on the wall will start to fall off or may not hold properly.  When mixing water and plaster, you should always add in the plaster to the water. Never do the opposite – adding water to the plaster. Plus, the consistency of the mix should resemble something of a melting ice cream. A good way to check if the mix has achieved the right consistency is to put in a stick straight into it. If the stick stands on its own, then it is a sign that the consistency is perfect. Ideally, you should use about equal quantities of water and plaster to create the mix.

Be Clean

Remember to never contaminate the plaster mix. Whether it is your hands, tools, or anything else, it should always be clean. If the plaster is contaminated and you use it on the wall, then it is very likely that the plaster will set far too fast. You might even see drags and pulls in the plaster finish. As such, it is recommended that you thoroughly clean all the plastering tools and bucket, and ensure that they are shiny new before you start mixing in the plaster.

Plastering Bead

To make sure that the corners of a wall are plastered clean and sharp, you will have to use plaster beads. You can try to give the edges a sharp look without resorting to them, but using a bead will give you a much more perfect result. These beads are needed in DIY and house renovation too and can be used to create sharp edges of both interior and exterior walls. While metal beads are used for interiors, plastic beads are preferred for the exteriors.

No Over Polish

Don’t over polish the final layer of plaster. If you do so, then the surface can look so smooth and shiny that you might see reflections on it. And this is something that is not at all preferred when plastering a wall. If you put up a wallpaper on such a surface, then it might peel off easily from certain areas while stick rigidly in other sections. This can turn out to be very damaging to the look of the plastered wall. Ideally, the surface must feel like that of an eggshell.

Applying Water To Surface

Sometimes, you will have to apply water to the surface when plastering it. Though many people do this by splashing some water from a bucket, this is not an efficient way to do the job. Instead, use a spray bottle and lightly spray the water on the area you want to wet. Just ensure that the water is perfectly clean.

Leave a Reply